RC Helicopters area
How it all Started…
  • Nexus 30 – first heli
  • GPH 346
  • JR Ergo Gasser
  • X-Cell 60 Graphite
  • Raptor 30
  • Raptor 60
  • Mini Tornado

    New Articles:

  • Painting Canopies
  • Painting Plastic Canopies
  • Tinting Canopies
  • Limited Slip Drive Setup
  • CJY Muscle Pipe Setup
  • Futaba GV-1 Setup
  • Setting Your Curves
  • Heading Hold Gyros
  • Balancing blades
  • NiCd Battery Care
  • Li-Po monitor
  • RC helicopters FAQ
  • GREAT QUOTE!

  • Canopy for RC helicopters directory


  • Century Swift
  • Jabo
  • Piccolo
  • Raptor 30 V2
  • Hornet
  • Hirobo X.R.B. Lama & Keyence Revolutor
  • Protech Zoom 400
  • Kyosho EP Caliber M24
  • Kyosho Concept 46VR

    Airplanes area:

  • Edge 540 - my latest plane!
  • RC Kit Reviews
  • Tips & Techniques
  • NiCd Battery Care
  • Miscellaneous
  • RV-8 my full-size plane

    Other:

  • Control Line explanation
  • Free Flight

    About the Author



    Similar pages:
  • rigging gear
  • rigging of picture
  • mening of rigging
  • rc rigging wires
  • Pictures of rigging
  • wire rigging plane rc
  • landing gear straps brass
  • rigging phnenix yachts
  • crimping rigging wire
  • wire tuck for rigging picture


  • If you're going to use the rigging wire method, I recommend using small brass tubing for the sleeve, and thread it as shown below. Finish by crimping the sleeve with electrical crimping pliers.

    Use small landing gear straps to pass the rigging wire through and attach to the rudder & stab.

    Here's a photo of how I recommend you hook up the other end of the wire...

    Use nylon landing gear straps to eliminate metal-to-metal radio noise problems. Also, use 2-56 screws and nuts through the surfaces - there's a hardwood dowel embedded in the surface.

     



    Comments:
    Write new one